Installation, Operation, and Maintenance 5
Procedure 4. Connecting Cables 46
5890 Series II GC 46
6890A GC 47
6890 Plus and 6890N GCs 48
6850 GC 49
Testing the connections 49
Procedure 5. Installing the G2911AA Software on the PC 50
Procedure 6. Installing the G2614A Tray 51
Procedure 7. Installing the G2615A Bar Code Reader 53
Procedure 8. Install the G2912A ALS Controller 55
Temperature and humidity ranges 55
Ventilation requirements 55
Benchtop space requirements 56
Dimensions 56
Orientation 57
Electrical requirements 57
Verifying G2912A ALS Controller power configuration 59
Procedure 9. Replacing the Inlet Chassis Cover (6890A) 60
Procedure 10. Installing a G2612A Controller Board (6890
Plus) 61
Procedure 11. Configuring Your GC and Data System 65
GC 65
Data system 65
Procedure 12. Updating the Firmware 66
All GC and ALS systems 66
6890A, 6890 Plus and 5890 Series II GCs 67
Other ways to check firmware revisions 67
Making A Trial Run 68
To Next Page
Loading...
Need help?
General
