Operational Commands
7210 SAS D, E, K OS Quality of Service Guide Page 155
The no form of this command sets the scope of the policy to the default of template.
Default template
Parameters exclusive — When the scope of a policy is defined as exclusive, the policy can only be applied to one
interface. If a policy with an exclusive scope is assigned to a second interface an error message is
generated. If the policy is removed from the exclusive interface, it will become available for assignment
to another exclusive interface.
The system default policies cannot be put into the exclusive scope. An error will be generated if scope
exclusive is executed in any policies with a policy-id equal to 1.
template — When the scope of a policy is defined as template, the policy can be applied to multiple
interfaces on the router.
Default QoS policies are configured with template scopes. An error is generated if you try to modify the
template scope parameter to exclusive scope on default policies.
To Next Page
Loading...
Need help?
General
