Generic Commands
Page 154 7210 SAS D, E, K OS Quality of Service Guide
The no form of the command removes the explicit association of the remark policy and associates
the default remark policy. In other words, if remarking is enabled and no remark policy is
executed, then the default remark policy is used to mark packets sent out. If no remark policy is
executed and remarking is disabled, then packets are not remarked at all.
Parameters policy-id — The parameter that uniquely identifies the remark policy.
Values 1 — 65535
remarking
Syntax no remarking
Context config>qos>network>egress
Description
Platforms Supported: 7210 SAS-K
This command enables the system to remark egress packets sent out of access-uplink ports.
When remarking is enabled, the remark policy configured in the QoS policy context is used to
determine the FC to QoS bit mapping. For example, when remarking is enabled in the network
QoS policy, the remark policy associated with network QoS policy is used to determine the FC to
Dot1p mapping to use for marking packets sent out of access-uplink ports.
Please refer to the remark policy that can be used to configure FC to priority bit markings in
different QoS policies associated with different service entities, in the chapter on remark policies.
For more information, see Table 7, Summary of remark policy and attachment points for 7210
SAS-K, on page 54.
The no form of the command disables remarking.
Default no remarking - Remarking is disabled by default.
scope
Syntax scope {exclusive | template}
no scope
Context config>qos>network policy-id
Description
This command configures the network policy scope as exclusive or template.
To Next Page
Loading...
Need help?
General
