Operational Commands
7210 SAS D, E, K OS Quality of Service Guide Page 309
mac-criteria
Syntax [no] mac-criteria [any|dot1p-only] policy id
Context config>qos>sap-ingress
Description Platforms supported: 7210 SAS-D and 7210 SAS-E
The mac-criteria based SAP ingress policies are used to select the appropriate ingress meters and
corresponding forwarding class for matched traffic.
User can specify either 'any' or dot1p-only' as the sub-criteria. The sub-criteria determines what fields can be
used to match traffic. The resource allocation for classification is affected by the sub-criteria in use. Please
see the section on SAP ingress resource allocation for L2 and L3 criteria for more information.
This command is used to enter the node to create or edit policy entries that specify MAC criteria.
7210 SAS OS implementation will exit on the first match found and execute the actions in accordance with
the accompanying action command. For this reason entries must be sequenced correctly from most to least
explicit.
The no form of this command deletes all the entries specified under this node. Once mac-criteria entries are
removed from a SAP ingress policy, the mac-criteria is removed from all services where that policy is
applied.
Default dot1p-only
Parameters any — Specifies that entries can use the other MAC header fields for matching.dot1p-only — Specifies
that entries can use only the Dot1p field.
policy-id — -The policy-id that uniquely identifies the policy.
Values 1 — 65535
ip-criteria
Syntax [no] ip-criteria
Context config>qos>sap-ingress
Description Platforms supported: 7210 SAS-K.
IP criteria-based SAP ingress policies are used to select the forwarding class for matched traffic.
This command is used to enter the context to create or edit policy entries that specify IP criteria DiffServ
code point.
7210 SAS OS implementation will exit on the first match found and execute the actions in accordance with
the accompanying action command. For this reason entries must be sequenced correctly from most to least
explicit.
NOTE: Before associating a SAP ingress policy configured to use IPv4 criteria with a SAP, resources must
be allocated to it. Please read the 7210 Basic Systems Guide for more information about this CLI command
and resource allocation.
To Next Page
Loading...
Need help?
General
