Service Ingress QoS Policy Commands
Page 308 7210 SAS D, E, K OS Quality of Service Guide
removed from a SAP ingress policy, the IP criteria is removed from all services where that policy is applied.
Default dscp-only
Parameters any — -Specifies that entries can use any of the fields available under ip-criteria (Example - IP source, IP
destination, IP protocol fields can be used) for matching
dscp-only — Specifies that entries can use the IP DSCP field or IP precedence field.
policy-id — -The policy-id that uniquely identifies the policy.
Values 1 — 65535
ipv6-criteria
Syntax [no] ipv6-criteria [any | dscp-only] policy-id
Context config>qos>sap-ingress
Description Platforms supported: 7210 SAS-D and 7210 SAS-E
IPv6 criteria-based SAP ingress policies are used to select the appropriate ingress meters and corresponding
forwarding class for matched traffic.
This command is used to enter the node to create or edit policy entries that specify IPv6 criteria such as IP
quintuple lookup or DiffServ code point.
The 7210 OS implementation will exit on the first match found and execute the actions in accordance with
the accompanying action command. For this reason entries must be sequenced correctly from most to least
explicit.
NOTE: Before associating a SAP ingress policy configured to use IPv6 criteria with a SAP, resources must
be allocated using the CLI command config> system> resource-profile>ingress-internal-tcam> qos-sap-
ingress-resource> ipv6-ipv4-match-enable. Please read the 7210 Basic Systems Guide for more information
about this CLI command and resource allocation.
The no form of this command deletes all the entries specified under this node. Once ipv6-criteria entries are
removed from a SAP ingress policy, the ipv6-criteria is removed from all services where that policy is
applied.
Parameters any — -Specifies that entries can use any of the fields available under ipv6-criteria (Example - IPv6 source,
IPv6 destination, IPv6 protocol fields can be used) for matching
dscp-only — Specifies that entries can use the IP DSCP field or IPv6 precedence field.
policy-id — -The policy-id that uniquely identifies the policy.
Values 1 — 65535
To Next Page
Loading...
Need help?
General
