Operational Commands
7210 SAS D, E, K OS Quality of Service Guide Page 307
Default 1
Parameters queue-id — specifies the queue-id for the queue.
Values [1..8]
ip-mac-match
Syntax [no] ip-mac-match {ip-first | mac-first}
Context config>qos>sap-ingress
Description Platforms supported: 7210 SAS-D only.
This command must be executed if user intends to match on both IP and MAC criteria in a SAP ingress
policy. If this command is not executed software does not allow for configuration of both IP and MAC
criteria in a SAP ingress policy. In other words, without this command in a SAP ingress policy IP and MAC
criteria are mutually exclusive.
User also has the option to specify if all the IP criteria entries configured in the policy need to be matched
first followed by all the MAC criteria entries or viceversa. In other words, if ip-first is configured all the IP
criteria entries are matched and only if there are no matches in the MAC criteria entries are matched. If a
match is found no further matches are done and the actions associated with the matched entry are taken.
Default no ip-mac-match
Parameters ip-first — Match all the IP criteria entries first before matching any of the MAC entries.
mac-first — Match all the MAC criteria entries first before matching any of the IP entries.
ip-criteria
Syntax [no] ip-criteria [any|dscp-only] policy id
Context config>qos>sap-ingress
Description Platforms supported: 7210 SAS-D and 7210 SAS-E
IP criteria-based SAP ingress policies are used to select the appropriate ingress meter and corresponding
forwarding class for matched traffic.
User can specify either 'any' or 'dscp-only' as the sub-criteria. The sub-criteria determines what fields can be
used to match traffic. The resource allocation for classification is affected by the sub-criteria in use. Please
see the section on SAP ingress resource allocation for L2 and L3 criteria for more information.
This command is used to enter the context to create or edit policy entries that specify IP criteria DiffServ
code point.
7210 SAS OS implementation will exit on the first match found and execute the actions in accordance with
the accompanying action command. For this reason entries must be sequenced correctly from most to least
explicit.
The no form of this command deletes all the entries specified under this node. Once IP criteria entries are
To Next Page
Loading...
Need help?
General
