IP QoS Policy Match Commands
Page 322 7210 SAS D, E, K OS Quality of Service Guide
precedence bits value that will match the IP precedence rule.
Values 0 — 7
mask — The mask to use for the match.
src-ip
Syntax src-ip {ip-address/mask | ip-address netmask}
no src-ip
Context config>qos>sap-ingress>ip-criteria>entry>match
config>qos>sap-egress>ip-criteria>entry>match
config>qos>sap-ingress>ipv6-criteria>entry>match
Description This command configures a source IP or IPv6 address range to be used as an SAP QoS policy match
criterion.
To match on the source IP or IPv6 address, specify the address and its associated mask, e.g. 10.1.0.0/16. The
conventional notation of 10.1.0.0 255.255.0.0 can also be used.
The no form of the command removes the source IP or IPv6 address match criterion.
Default No source IP match criterion.
Parameters ip-address | ipv6-address — The IP or IPv6 address of the source IP interface. This address must be unique
within the subnet and specified in dotted decimal notation.
Values ip-address: a.b.c.d
mask: 1 — 32
netmask a.b.c.d (dotted quad equivalent of mask length)
Values ipv4-prefix: a.b.c.d
ipv4-prefix-length: 0 -- 32
ipv6-prefix: x:x:x:x:x:x:x:x (eight 16-bit pieces)
x:x:x:x:x:x:d.d.d.d
x: [0..FFFF]H
d: [0..255]D
ipv6-prefix-length: 0 -- 128
netmask Specifies the subnet mask in dotted decimal notation.
Values 0.0.0.0 - 255.255.255.255
mask — The subnet mask length, expressed as an integer or in dotted decimal notation.
Values 0 — 32
netmask — Specify the subnet mask in dotted decimal notation.
Values a.b.c.d (dotted quad equivalent of mask length)
To Next Page
Loading...
Need help?
General
