Service Ingress MAC QoS Policy Match Commands
Page 324 7210 SAS D, E, K OS Quality of Service Guide
Service Ingress MAC QoS Policy Match Commands
dot1p
Syntax dot1p dot1p-value [dot1p-mask]
no dot1p
Context config>qos>sap-ingress>mac-criteria>entry
Description Platforms Supported:7210 SAS-D and 7210 SAS-E.
The IEEE 802.1p value to be used as the match criterion.
Use the no form of this command to remove the dot1p value as the match criterion.
Default None
Parameters dot1p-value — Enter the IEEE 802.1p value in decimal.
Values 0 — 7
dot1pmask — This 3-bit mask can be configured using the following formats:
To select a range from 4 up to 7 specify p-value of 4 and a mask of 0b100 for value and mask.
Default 7 (decimal) (exact match)
Values 1 — 7 (decimal)
dst-mac
Syntax dst-mac ieee-address [ieee-address-mask]
no dst-mac
Context config>qos>sap-ingress>mac-criteria>entry
Description Configures a destination MAC address or range to be used as a Service Ingress QoS policy match criterion.
The no form of this command removes the destination mac address as the match criterion.
Default none
Format Style Format Syntax Example
Decimal D 4
Hexadecimal 0xH 0x4
Binary 0bBBB 0b100
To Next Page
Loading...
Need help?
General
