Alcatel-Lucent 7210 SAS Series User Manual

7210 SAS D, E, K OS Quality of Service Guide Page 369
A:Dut-A>show>qos# access-egress
PIR Adpt Rule
min — The operational PIR for the queue will be equal to or
greater than the administrative rate specified using the rate com-
mand.
max — The operational PIR for the queue will be equal to or
less than the administrative rate specified using the rate com-
mand.
closest — The operational PIR for the queue will be the rate
closest to the rate specified using the rate command.
High Slope/Low slope
QueueId
Displays the Queue identifier associated with the sap-egress
QoS policy.
State
Displays the state of the queue. The state of the queue can be
either “Up” or “Down”
Start Avg
Specifies the low priority or high priority RED slope position for
the shared buffer average utilization value where the packet dis-
card probability starts to increase above zero.
Max Avg
Specifies the percentage of the shared buffer space for the buffer
pool at which point the drop probability becomes “1”.This
parameter is expressed as a decimal integer.
Max Prob
Specifies the high priority RED slope position for the maximum
non-one packet discard probability value before the packet dis-
card probability rises directly to one.
Burst Sizes and Time Average Factor
QueueId
Displays the Queue identifier associated with the sap-egress
QoS policy
CBS
Displays the configured CBS value
MBS
Displays the configured MBS value
Time Average Fac-
tor
Displays the value of the time average factor in use
Queue-Mgmt
Displays the Queue management policy in use
Label Description (Continued)

Alcatel-Lucent 7210 SAS Series Specifications

General

Brand	Alcatel-Lucent
Model	7210 SAS Series
Category	Switch
Language	English