Configuring the Server Farm Configuring Server Load Balancing
page 44-20 OmniSwitch AOS Release 6 Network Configuration Guide September 2009
13 Select Microsoft in the Manufacturers window.
If the Microsoft loopback adapter has been installed it will be listed in the Network Adapter window
as shown in the figure below. If this adapter is listed, proceed to Step 17 on page 44-20. Otherwise,
proceed to Step 14.
14 Click the Have Disk... button.
15 Load the CD or floppy disc with the Microsoft loopback adapter.
16 If needed, enter the file and path name of the Microsoft loopback adapter or click the Browse... button
to search for the file.
17 Click the Next button in the Select Network Adapter window (see the figure in Step 13 on page
44-20).
18 Click the Next button (this will install all default values) in the Start Hardware Installation window.
19 Click the Next button.
Click “Have Disk...”
when done.
Select “Microsoft.”
Enter the file and path name
or click the “Browse...”
button to search for the file.
Click “OK” when
done.
To Next Page
Loading...
