EasyManua.ls Logo

Alcatel-Lucent OmniSwitch 6850-48 - Page 1153

Alcatel-Lucent OmniSwitch 6850-48
1162 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Index
OmniSwitch AOS Release 6 Network Configuration Guide September 2009 Index-5
gvrp enable-vlan-advertisement command 5-12
gvrp enable-vlan-registration command 5-11
gvrp maximum vlan command 5-8
gvrp portcommand 5-5
gvrp registration command 5-9
gvrp static-vlan restrictcommand 5-5
GVRP Timers 5-10
gvrp transparent switchingcommand 5-8
gvrpcommand 5-5
H
health interval command 15-11, 45-45
health statistics reset command 45-47
health threshold command 45-43
health threshold limits
displaying 45-44
Hot Standby Routing Protocol
see HSRP
Hsecu.img 36-9
HSRP
not compatible with VRRP 32-3
I
ICMP 24-29
control 24-32
QoS policies for 40-61
statistics 24-32
icmp messages command 24-31
icmp type command 24-30, 24-31
IEEE 21-1
IGMP
multicast ACLs 41-1, 41-14
IGMP Spoofing 42-19
Institute of Electrical and Electronics Engineers
see IEEE
interfaces admin command 1-11
interfaces alias command 1-14
interfaces autoneg command 1-18
interfaces crossover command 1-19
interfaces duplex command 1-17
interfaces flood multicast command 1-12
interfaces flood rate command 1-13
interfaces hybrid autoneg command 1-25
interfaces hybrid crossover command 1-26
interfaces hybrid duplex command 1-24
interfaces hybrid forced-copper command 1-22
interfaces hybrid forced-fiber command 1-21
interfaces hybrid preferred-copper command 1-22
interfaces hybrid preferred-fiber command 1-23
interfaces hybrid speed command 1-23
interfaces ifg command 1-17
interfaces max frame command 1-14
interfaces no l2 statistics command 1-11
interfaces speed command 1-16
inter-frame gap value 1-17
Internet Control Message Protocol
see ICMP
Internet Packet Exchange
see IPX
interswitch protocols
AMAP 20-1, 20-3
application examples 20-8
defaults 20-2
specifications 20-2
IP 24-1, 25-1
application examples 24-4, 25-3
ARP 24-12
defaults 24-3
directed broadcast 24-23
ICMP 24-29
ping 24-32
protocols 24-5, 25-9
router ID 24-16
router port 24-8
router primary address 24-16
specifications 24-3
static route 24-11, 26-18
tracing an IP route 24-33
TTL value 24-17
UDP 24-33
verify information about 24-36, 25-16
ip access-list address command 28-15
ip access-list command 28-15
ip default-ttl command 24-17
ip directed-broadcast command 24-23
ip dos scan close-port-penalty command 24-26
ip dos scan decay command 24-27
ip dos scan tcp open-port-penalty command 24-26
ip dos scan threshold command 24-27
ip dos scan udp open-port-penalty command 24-26
ip dos trap command 24-27
ip helper address command 31-9, 36-30
ip helper avlan only command 31-11, 36-30
ip helper boot-up command 31-12
ip helper forward delay command 31-10
ip helper maximum hops command 31-11
ip helper per-vlan command 31-11
ip helper standard command 31-11
ip interface command 28-3
configuring authenticated VLANs 36-26
ip load rip command 28-3, 28-6
ip multicast igmp-proxy-version command 42-10, 42-25
ip multicast neighbor-timeout command 42-10, 42-16,
42-17, 42-18, 42-25, 42-32
ip multicast query-interval command 42-14, 42-15, 42-29
ip multicast static-member command 42-12
ip multicast static-neighbor command 42-26
ip multicast static-querier command 42-12
IP Multicast Switching
see IPMS
ip multicast switching command 42-9, 42-19, 42-24, 42-34
IP multinetting 24-7
ip redist command 28-12
ip rip force-holddowntimer command 28-9
ip rip garbage-timer command 28-10
ip rip holddown-timer command 28-10

Table of Contents

Other manuals for Alcatel-Lucent OmniSwitch 6850-48

Related product manuals