EasyManua.ls Logo

Alcatel-Lucent OmniSwitch 6850-48 - Page 1152

Alcatel-Lucent OmniSwitch 6850-48
1162 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Index
Index-4 OmniSwitch AOS Release 6 Network Configuration Guide September 2009
DNS
URL for Web browser authentication clients 36-8
DoS 24-23
enabling traps 24-27
setting decay value 24-27
setting penalty values 24-26
Setting Port Scan Penalty Value 24-27
DSCP
trusted ports 40-28
DVMRP 42-8
defaults 5-2
dynamic link aggregation 23-1
application examples 23-4, 23-29
defaults 23-3
group actor administrative key 23-15
group actor system ID 23-16
group actor system priority 23-16
group administrative state 23-15
group partner administrative key 23-17
group partner system ID 23-18
group partner system priority 23-17
groups 23-11
assigning ports 23-12
creating groups 23-11
deleting groups 23-11
group names 23-14
removing ports 23-13
LACPDU bit settings 23-19, 23-23
LACPDU frames 23-19, 23-23
Link Aggregation Control Protocol (LACP) 23-7
MAC address 23-16, 23-18, 23-20, 23-25
port actor administrative priority 23-21
port actor port priority 23-22
port actor system administrative states 23-19
port actor system ID 23-20
port partner administrative key 23-25
port partner administrative priority 23-27
port partner administrative state 23-23
port partner administrative system ID 23-25
port partner administrative system priority 23-26
port partner port administrative status 23-27
ports 23-12
specifications 23-2
verify information about 23-32
dynamic log
LDAP accounting servers 35-26
dynamic VLAN port assignment
mobile ports 6-4
secondary VLANs 6-13
VLAN rules 8-1
E
errors 46-8
Ethernet
application examples 1-29
defaults 1-2, 1-3
flood rate 1-12
frame size 1-14
full duplex 1-17, 1-24
half duplex 1-17, 1-24
multicast traffic 1-12
specifications 1-2
verify information 1-31
Ethernet OAM
application example 15-7
configuration 15-8
Connectivity Fault Management 15-4
Alarm Indication Signal Messages 15-5
Continuity Check Messages 15-5
Link Trace Messages 15-5
Loop-back Messages 15-5
defaults 15-2
overview 15-4
specifications 15-2
verification 15-12
ethoam association ccm-interval command 15-9
ethoam association command 15-7
ethoam association mhf command 15-8, 15-9, 15-10
ethoam association-default command 15-9
ethoam domain command 15-7
ethoam end-point command 15-7
ethoam intermediate-point command 15-7
ethoam linktrace command 15-10
ethoam loopback command 15-10
F
Fast Ethernet
see Ethernet
Fast Spanning Tree 13-6
filtering lists
see ACLs
filters
IPX GNS 33-13
IPX RIP 33-12
IPX SAP 33-12
flow command 1-19, 1-27
forced copper 1-4
configuring 1-22
forced fiber 1-4
configuring 1-21
frame type 21-6
G
GARP
active member 5-3
messages 5-3
passive member 5-3
Generic Attribute Registration Protocol
see GARP
Gigabit Ethernet
see Ethernet
GVRP
application examples 5-5
display configuration on specified port 5-13
specifications 5-2
gvrp applicant command 5-10

Table of Contents

Other manuals for Alcatel-Lucent OmniSwitch 6850-48

Related product manuals