Chapter 5: Installing AT-StackQS and AT-x9EM/XT4 Cards
104
Guidelines
Please observe the following guidelines when handling AT-StackQS and
AT-x9EM/XT4 Cards.
Wear an anti-static device when handling the card.
Caution
The device can be damaged by electrostatic discharge (ESD). Be
sure to follow standard ESD protections procedures, such as
wearing a wrist or foot strap, when installing the device. E106
Hold the card by its faceplate or edges.
Never touch the electronic components on the top or bottom of the
card.
Do not remove the card from its anti-static bag until you are ready
to install it in the switch.
If you need to remove the card from the switch, immediately return
it in its anti-static bag and packaging container.
To Next Page
Loading...
