Chapter 13: Building the Stack with Copper or SFP Gigabit Ports
178
4. Save your changes with the WRITE command in the Privilege Exec
mode.
5. Restart the switch with the REBOOT command.
6. Start a new local management session.
7. Verify your changes with the SHOW STACK and SHOW RUNNING-
CONFIG INTERFACE commands.
Configuring
Member Switches
- Part I
Perform Part I in Table 24 to configure a member switch.
Table 24. Configuring Member Switches - Part I
Step Description and Command
1 Power on a member switch and start a local management session. Refer to “Starting
a Local Management Session” on page 142.
2 Enter the ENABLE and CONFIGURE TERMINAL commands to move to the Global
Configuration mode:
awplus> enable
awplus# configure terminal
Enter configuration commands, one per line. End with CNTL/Z.
awplus(config)#
Step 3 sets the member switch’s ID number.
3 Set the ID number of the member switch with the STACK RENUMBER command.
Each switch must have a unique ID number. The default value is 1. The range is 1 to
4. If you are using the worksheet on “Stack Worksheet” on page 78, refer there for the
ID numbers. This example changes the switch’s ID number from the default value 1 to
the new value 2.
awplus(config)# stack 1 renumber 2
% Warning: the new ID will not become effective until the stack-
member reboots.
% Warning: the boot configuration may now be invalid.
The remaining steps reboot the unit. (You do not have to update the configuration file with the
WRITE command after changing a switch’s ID number.)
4 Enter the EXIT command to return to the Privileged Exec mode.
awplus(config)# exit
To Next Page
Loading...
Need help?
General
