Allied Telesis AlliedWare Plus Installation Guide

x930 Series Installation Guide for Virtual Chassis Stacking
23
SFP Ports The AT-x930-28GSTX Switch supports the following types of transceivers
in its twenty four SFP ports:
 100Base-FX, 1000Base-T, and 1000Base-SX/LX SFP transceivers
 Single-port BiDi 100Base-FX and 1000Base-LX SFP transceivers
 1000Base-ZX SFP transceivers
Note
The SFP ports and copper ports on the AT-x930-28GSTX Switch
are paired together. Only one port in a pair can be active at a time.
For more information, refer to “SFP Ports” on page 38.
Note
SFP transceivers must be purchased separately. For a list of
supported transceivers, refer to the product's data sheet on the
Allied Telesis website.
SFP+ Ports The four SFP+ ports support the following types of transceivers:
 SFP 1000Base-SX/LX SFP transceivers
 SFP single-port BiDi 1000Base-LX transceivers
 SFP 1000Base-ZX transceivers
 SFP+ 10Gbps, 10GBase-SR/LR fiber optic transceivers
 SFP+ 10Gbps AT-SP10TW direct connect twinax cables with
SFP+ transceiver-style connectors
Note
The SFP+ ports do not support 100Mbps 100Base-FX transceivers.
Note
The port support full-duplex mode only. They do not support half-
duplex mode.
Note
SFP and SFP+ transceivers must be purchased separately. For a
list of supported transceivers, refer to the product’s data sheet on
the Allied Telesis web site.

Allied Telesis AlliedWare Plus Specifications

General

Brand	Allied Telesis
Model	AlliedWare Plus
Category	Switch
Language	English