Allied Telesis AlliedWare Plus - Figure 63: Securing the Switch to the Plywood Base

Chapter 8: Installing the Switch on a Wall
132
Figure 63. Securing the Switch to the Plywood Base
4. Repeat this procedure to install other switches on a wall.
5. Do one of the following:
 If any of the switches contain the AT-PWR250-80 DC Power
Supply, go to Chapter 9, “Wiring the DC Connector on the AT-
PWR250-80 Power Supply” on page 137.
 Otherwise, go to Chapter 10, “Displaying the AlliedWare Plus
Version Number” on page 141.