Chapter 13: Building the Stack with Copper or SFP Gigabit Ports
182
Figure 83. SHOW RUNNING-CONFIG INTERFACE Command for
Member Switches
Note the following:
1 - These lines designate the stack ports for the default
provisioned switch. You can ignore these lines on member
switches.
2 - These lines designate the trunk ports for the member switch
you are configuring. The switch ID number in the PORT parameter
should match the ID number of the switch and the port numbers
should be the Gigabit ports of the trunk. Repeat the procedure if
the display does not include these lines.
6. Go to “What to Do Next for Member Switches” on page 183.
awplus# show running-config interface
interface port1.0.1-1.0.26
switchport
switchport mode access
!
stack enable front-panel-ports
!
interface port1.0.27-1.0.28
stackport
!
interface port2.0.1-2.0.24
switchport
switchport mode access
!
interface port2.0.1-2.0.8
stackport
!
interface port2.0.27-2.0.28
switchport
switchport mode access
!
awplus#
2
1
To Next Page
Loading...
Need help?
General
