113
Chapter 6
Installing the Switch on a Table
To install the switch on a table, perform the following procedure:
Warning
Switches should not be stacked on a table or desktop because that
could present a personal safety hazard if you need to move or
replace units. E91
Warning
The switch is heavy. Always ask for assistance when moving or
lifting the device so as to avoid injuring yourself or damaging the
equipment.
1. Review the procedure in “Choosing a Site for the Switch” on page 89 to
verify that the selected site is suitable for the unit.
2. Check to be sure that the table or desk is strong enough to support the
weight of the switch.
3. Check to be sure that all of the appropriate components are included in
the shipping container. Refer to “Unpacking the Switch” on page 90.
4. Place the switch upside down on a level, secure table or desk.
5. Install the seven bumper feet to the bottom of the switch. Refer to
Figure 52.
Three bumper feet should be installed along the front edge of the
bottom panel and four feet along the rear edge.
Figure 52. Installing the Bumper Feet
To Next Page
Loading...
Need help?
General
