Chapter 6: Installing the Switch on a Table
114
Note
The bumper feet are only to be used if you are installing the switch
on a table or desk. Do not install the bumper feet if you are installing
the unit in an equipment rack or on a wall.
6. Turn the chassis over.
7. Repeat this procedure on any other switches that are to be installed on
a table or desktop.
8. Do one of the following:
If any of the switches have the AT-PWR250-80 DC Power Supply,
go to Chapter 9, “Wiring the DC Connector on the AT-PWR250-80
Power Supply” on page 137.
Otherwise, go to Chapter 10, “Displaying the AlliedWare Plus
Version Number” on page 141.
To Next Page
Loading...
