Allied Telesis AlliedWare Plus - Figure 77: Returning to the Privileged Exec Mode; Figure 78: Saving the Priority Values with the WRITE Command; Figure 79: SHOW STACK Command with New Switch Priority Numbers

Chapter 11: Building the Stack with SFP+ Ports S1 and S2
158
To assign the priority value to 2 to the switch with the ID number 2, you
enter:
awplus(config)# stack 2 priority 2
6. After setting the priority values, enter the EXIT command to return to
the Privileged Exec mode. Refer to Figure 77.
Figure 77. Returning to the Privileged Exec Mode
7. Enter the WRITE command to save your changes in the configuration
file of the stack. The switch displays the confirmation prompt in
Figure 78.
Figure 78. Saving the Priority Values with the WRITE Command
8. Enter the SHOW STACK command to verify the new priority numbers.
Figure 79 is an example of a stack of four switches:
Figure 79. SHOW STACK Command with New Switch Priority Numbers
9. To end the management session, enter the EXIT command.
10. Go to Chapter 14, “Cabling the Networking Ports” on page 185, to
complete the installation.
awplus(config)# exit
awplus#
awplus# write
Building configuration ...
[OK]
awplus#
awplus# show stack
Virtual Chassis Stacking summary information
ID Pending ID MAC address Priority Status Role
1 - nnnn:nnnn:nnnn 1 Ready Active Master
2 - nnnn:nnnn:nnnn 2 Ready Backup Member
3 - nnnn:nnnn:nnnn 3 Ready Backup Member
4 - nnnn:nnnn:nnnn 4 Ready Backup Member
Operational Status Normal operations
Stack MAC address nnnn:nnnn:nnnn