Chapter 5: Installing AT-StackQS and AT-x9EM/XT4 Cards
112
14. If you purchased AT-StackQS Cards for other sx930 Switches, repeat
this procedure to install the cards.
15. Do one of the following:
To install the switch on a table, go to Chapter 6, “Installing the
Switch on a Table” on page 113.
To install the switch in an equipment rack, refer to Chapter 7,
“Installing the Switch in an Equipment Rack” on page 115.
To install the switch on a wall, refer to Chapter 8, “Installing the
Switch on a Wall” on page 121.
To Next Page
Loading...
