156
ML-5120A
3. Initial Settings
2
Specifying Communication Schedules
(1) Set communication schedules in "RS-485 COMMUNICATION SETUP." Press
the setting button to be changed for this setting.
3
Specifying Equipment No.
(1) Press the "NETWORK #" setting button.
Enter the laser equipment No. in the range of 0 to 15 by using the numeric key-
pad and then press the ENT key.
⇒
For controlling multiple lasers by single personal computer, it is necessary to reg-
ister equipment No. (NETWORK #) for each equipment. Set equipment No. with-
out duplication. If duplication of equipment No. exists, a data collision will occur
on the communication line and the laser cannot be correctly operated.
(2) Press the "X" button.
Returns to the CONFIG screen.
To Next Page
Loading...
Need help?
General