1. Setting Welding Schedules
61
ML-5120A
Chapter 2 Various Settings
Introduction Part
Installation and
Preparation Part
Operating Part Maintenance Part Appendixes
SCHED MON STATUS CONFIG
Chapter 2
●
Various Settings
1. Screen Conguration
This section explains the method of setting various laser processing schedules
by using the laser controller. The set schedules can be protected so that they
cannot be changed.
Transition of Screens
This section explains how to see the SCHEDULE, MONITOR, STATUS, and
CONFIG screens to set a processing schedule.
There are 4 types of basic screen as shown below which are displayed on the liquid
crystal display of the laser controller. Each screen is selected to perform each setting
by the button arranged on the right side of each screen.
Each time the screen selecting button is pressed, each of the SCHEDULE screen,
MONITOR screen, STATUS screen, and CONFIG screen appears in sequence from
the top.
When laser light is output, the MONITOR screen is automatically displayed so that
the output energy can be checked.
When each of the screen selecting buttons is pressed:
Operating Part
MONITOR
Screen
STATUS
Screen
SCHEDULE
Screen
CONFIG
Screen
To Next Page
Loading...
Need help?
General