4. Setting the Laser Light Output Schedule
95
ML-5120A
Chapter 2 Various Settings
Introduction Part
Installation and
Preparation Part
Operating Part Maintenance Part Appendixes
Setting Laser Light Output Schedules
This section explains the how to set the SCHEDULE screen (fixed waveform
(FIX)).
⇒
256 types of output schedules can be set and registered with SCHEDULE num-
bers of #0 to #255. To perform laser processing, enter the registered SCHED-
ULE numbers and laser processing can be performed in the set output sched-
ules.
⇒
It is convenient if you enter the set output schedules in the Appendix "Output
Schedule Data Entry Table" in advance.
1
Setting Output Schedules by Fixed Waveform (FIX)
Set the output time and output value of laser light in "FLASH1" (first laser) to
"FLASH3" (third laser) by "FIX." Set the laser light that becomes a xed waveform by
up to 3 divisions.
In the following example, SCHEDULE No.: #0, peak value: 100 W, FLASH1: 3.6
ms/100%, COOL1: 0.0 ms, FLASH2: 2.4 ms/85%, COOL2: 0.0 ms, FLASH3: 1.9
ms/50%, up slope: 0.6 ms, and down slope: 1.2 ms are set as output schedules.
(1) Press the "SCHED" button to display the SCHEDULE screen.
(2) Press the "SCHEDULE" setting button.
Enter the SCHEDULE number by using the "<" and ">" buttons or numeric key-
pad and then press the ENT key.
(3) Press the "FORM" setting button to set "FIX."
(4) Press the "PEAK POWER" setting button.
Enter the laser output peak value by using the numeric keypad and then press
the ENT key.
<Note>
The settable value of laser output peak value is 0 to 120 W.
To Next Page
Loading...
Need help?
General