Amada ML-5120A EU - Deterioration Check

2. Checking the Equipment Status
71
ML-5120A
Chapter 2 Various Settings
Introduction Part
Installation and Preparation Part
Operating Part Maintenance Part Appendixes
Deterioration Check
It is recommended to do the deterioration check (Refresh) regularly to check the LD
status.
When the detected output is 90% or less of the that before shipping (Factory initial),
error No.045/FC-LD POWER DOWN occurs. Press the TROUBLE RESET button to
clear the error.
Check the PEAK POWER setting and prepare the FC-LD for replacement when the
value is lower than the deterioration rate shown below. It doesn't mean that the FC-
LD immediately reaches the end of its useful life even when error No.045/FC-LD
POWER DOWN occurs.
Indication of preparing FC-LD for replacement
PEAK POWER Deterioration rate
120 W Less than 90%
100 W Less than 80%
80 W Less than 70%
60 W Less than 60%
40 W Less than 50%
20 W Less than 40%