62
ML-5120A
1. Setting Welding Schedules
How to Use the Touch Panel
The laser controller of this laser equipment adopts a touch panel type that permits
touching the screen directly for an operation. Press the displayed button portion on
the screen with a nger to select a screen or perform each setting.
The colors of the setting buttons displayed on the basic screens are deep blue, black,
light blue, and blue. There is also the button with the green lamp.
(deep blue) / (black) / (light blue) / (w/ green lamp) button
The deep blue buttons are used to change a screen or display a setting window. The
black and light blue buttons are used to change ON/OFF setting.
Regarding the buttons with green lamp, the selected screen button is displayed in green.
Regarding the ON and OFF buttons, OFF lights out and ON lights up (blinks). When
the OFF button is pressed, a check window is displayed. If OFF is switched over to
ON by pressing the ON or YES button, the ON setting lights up (blinks).
Example:
→ When pressing ON → (blinking)
* There are some buttons that change the setting without
displaying a check window.
(blue) button
The blue button is used to set a numeric value.
When this button is pressed, a numeric keypad is displayed and then a numeric value
can be input. The input value is denitively set by pressing the
key.
Example:
→ →
Numbers of the numeric keypad
are pressed and then the
key
is pressed.
Blue button
Black button
Button with
green lamp
Light blue button
Deep blue button
To Next Page
Loading...
Need help?
General