Amsco 110LS - Cycle Count; Default Values

6-65
Sterilizer Operation Operator Manual 387366-389
6.20.9 Cycle Count From Supervisors Mode Screen (Screen 600), press CYCLE COUNT
button to change or view cycle count. Set Cycle Count screen is
displayed.
On Cycle Count screen, press button to change cycle count. A numeric
display is shown to enter value. Enter numeric value and press ENTER
button. The new value is shown. Range is 0 - 32767.
6.20.10 Default Values From Supervisors Mode Screen (Screen 600), press DEFAULT
VALUES button to default values. The Default Values screen is
displayed.
Press YES to default all values:
• Cycle Values
• Too Long In Step
•Units
• Machine Number
• Cycle Count
NOTE: Calibration values are not defaulted.
Press NO to cancel default values. Display returns to previous screen.