5-1
Control Interface Operator Manual 387366-389
CONTROL INTERFACE
5.1 General
Description
Touch screens allow the user to operate and program the sterilizer
by lightly touching (pressing) the appropriate touch-sensitive areas
on the display. On each screen, all buttons are touch sensitive areas.
When a button is pressed, the display area within the button
changes state.
After the sterilizer has been powered up, the display shows the
following screen:
Touch any portion of screen to proceed.
NOTE: Pressing the upper right on the screen enables the control
panel.
The In Standby Screen displays a “. . . Please Wait” message, then
displays the Log In Screen.
5.1.1 Log In
After touching the In Standby Screen, the display shows the following
screen:
Enter the Username.
To Next Page
Loading...
