Section 5 Measurement Examples
5-10
(12) Press the F9 (Storage Mode) key and F7 (Normal) to set Storage Mode to be
Normal.
(13) Press the F12 (return) key.
(14) Press the F11 (Adjust Range) key to optimize the measurement range.
(15) Press the Single key or the Continuous key to start the open loop output power
measurement. The measurement result 1 is shown as follows:
(16) Press the F1 (BS Output Level) key and set BS Output Level at –65.0 dBm.
(17) Press the F11 (Adjust Range) key to optimize the measurement range.
(18) Press the Single key or the Continuous key to start the open loop output power
measurement. The measurement result 2 is shown as follows:
To Next Page
Loading...
