Anritsu MT8801C - Page 310

C-1
• Numbers on the right indicate section and paragraph numbers in this operation manual.
Access Probe Measure Screen.............................................. 4.3.6 (7)
Access Probe Output Power measurement .......................... 4.3.6 (7)
Access Probe TX power measurement ................................ 4.3.6 (7)
ACCH DCC .......................................................................... 4.3.10 (1)
Adjust Range ........................................................................ 4.3.1 (2) (b)
AF Input/Output connectors ................................................. 3.1, 4.3.1
Alarm .................................................................................... 4.3.3
All 0 ...................................................................................... 4.3.6 (5)
All 1 ...................................................................................... 4.3.6 (5)
Allowable maximum power ................................................. 2.2.2
Alternate ............................................................................... 4.3.6 (5)
Alternate keys ....................................................................... 4.2 (2)
Amplitude error .................................................................... 4.3.6 (3)
Auto Set ................................................................................ 4.3.5
AUX Input connector ........................................................... 3.1, 4.3.1, 4.3.3
AUX Output connector ........................................................ 3.1, 4.3.3
Average Count ...................................................................... 4.2 (1)
AWGN Level ........................................................................ 4.3.5
AWGN On, Off .................................................................... 4.3.5
Baseband ............................................................................... 4.3.8 (2)
BASE_ID .............................................................................. 4.3.10 (1)
BS Output Level ................................................................... 4.3.5
Calibration ............................................................................ 4.3.1 (2) (b)
Calibration before measurement .......................................... 4.3.1 (2)
Call processing ..................................................................... 4.3.5, 4.3.13
Call processing test ............................................................... 3.2.1
Cal Mode .............................................................................. 4.3.5
Carrier Frequency ................................................................. 4.3.6 (2)
Carrier Frequency Error ....................................................... 4.3.6 (2)
Carrier Off Power ................................................................. 4.3.6 (4) (a), (5)
CDMA Reference Input ....................................................... 4.3.8 (2)
CDMA Reference Input connector ...................................... 3.1.2
CDMA Reference Output ..................................................... 4.3.8 (2)
CDMA Reference Output connector .................................... 3.1.2
CDMA Timing connector .................................................... 3.1.2
CDMA TX/RX test ............................................................... 4.3
Change Color ........................................................................ 4.3.4
Channel Level ....................................................................... 4.3.8 (2)
Channel Spacing ................................................................... 4.3.5
Cleaning the cabinet ............................................................. 7.1
Clock ..................................................................................... 4.3.3
Appendix C Index