Anritsu MT8801C - Page 313

Appendix C Index
C-4
OCNS Channel Walsh Code ................................................ 4.3.10 (1)
On/Off ratio .......................................................................... 4.3.6 (5)
Open Loop Power Control measurement ............................. 4.3.6 (8)
Open-loop power-control time response screen .................. 4.3.6 (8)
Operating the file .................................................................. 4.3.11
Optional accessories and peripherals ................................... 1.4
Options .................................................................................. 1.3.2
Origin Offset ......................................................................... 4.3.6 (2)
Outline of screen configuration ............................................ 3.2.2 (4)
Overview of functions .......................................................... 3.2.1
Overview of operation .......................................................... 3.2
Paging Channel Data Rate .................................................... 4.3.8 (1)
Paging Channel Level .......................................................... 4.3.8 (2)
Paging Channel Mode .......................................................... 4.3.8 (1)
Paging Channel Walsh Code ................................................ 4.3.10 (1)
Panel layout .......................................................................... 3.1
Panel layout diagram ............................................................ 3.1.3
Peak Vector Error ................................................................. 4.3.6 (2)
Phase Error (RMS) ............................................................... 4.3.6 (2)
Pilot Channel Level .............................................................. 4.3.8 (2)
Power Control Bit Pattern .................................................... 4.3.6 (1), 4.3.6 (5)
Power measure method ........................................................ 4.3.6 (1), 4.3.6 (5)
Power meter .......................................................................... 4.3.6 (1), 4.3.6 (5)
Power Meter Calibration ...................................................... 4.3.1 (2) (b)
Power Meter screen .............................................................. 4.3.6 (5)
Power switch......................................................................... 3.1, 4.1
Power vs Time (-6 us) .......................................................... 4.3.6 (5)
Power vs Time (1256 us)...................................................... 4.3.6 (5)
Precautions before storage ................................................... 7.2.1
Preparations before power-on .............................................. 2.3
Preparations before use ........................................................ 2
Protective grounding ............................................................ 2.3.1
Protective grounding terminal .............................................. 2.3.1, 3.1
r (Waveform Quality Factor)................................................ 4.3.6 (2)
PWR_STEP .......................................................................... 4.3.6 (1)
Rack mounting ...................................................................... 2.4
Range Down ......................................................................... 4.3.6 (7)
Range Up .............................................................................. 4.3.6 (7)
RBW ..................................................................................... 4.3.6 (9)
Rear panel layout .................................................................. 3.1.2
Recall .................................................................................... 4.3.10
Receiver (RX) measurement ................................................ 4.3.8
Receiver measurement example ........................................... 4.3.8 (4)