2-9
Device messages are classified into ten types according to valid ranges:
1. MT8801C common commands:
Valid in all MT8801C modes
2. Instrument Setup commands:
Valid in Instrument Setup panel mode
3. TX/RX tester commands:
Valid in TX/RX tester panel mode (on all TX/RX test screens)
4. Setup commands:
Valid in TX/RX tester panel mode (on all TX/RX test screens)
(Setup Common Parameter screen commands, Setup TX Measure Parameter
screen commands, Setup Template screen commands, Setup Analog TX Measure
Parameter screen commands, Setup RX Measure Parameter screen commands,
Setup Signal screen commands, Setup Analog RX Measure Parameter screen
commands, Setup Call Processing Parameter screen commands)
5. TX Measure commands:
Valid in a range defined on each TX Measure screen
6. Analog TX Measure commands:
Valid in a range defined on each Analog TX Measure screen
7. RX Measure commands:
Valid in a range defined on each RX Measure screen
8. Analog RX Measure commands:
Valid in a range defined on each Analog RX Measure screen
9. Call Processing commands:
Valid in a range defined on each Call Processing screen
These device messages are listed below.
• Relationship between screen hierarchies and commands
[MT8801C common commands]:
Valid in all MT8801C modes regardless of screen hierarchies
Save/Recall command
FD command (Verify)
Copy command
Single/Continuous switching command
Preset command
Panel mode switching command
Switch to upper screen command (BS: Back Screen)
Extended event status command (END, ERR)
2.5 Device Message List
To Next Page
Loading...
