Anritsu MT8801C - Page 361

Section 2 Device Messages
2-36
(3) Frame Error Rate screen commands
• Program Msg of the Frame Error Rate screen commands are valid only at Frame
Error Rate screen.
Query Msg of the Frame Error Rate screen commands are valid at all the screens of
the TX/RX measurement screens.
Measure Measure Start FERSA --- ---
Measure Stop FERSO --- ---
Sample Sample FERSAMPLE n
FERSAMPLE? n n:5 to 10000 Frames
in multiples of 5 only
FER FER FER r FER? u r:0.0 to 100.0 %
BS Output Power Cal BS Output Power Cal OLVLCAL --- ---
AWGN AWGN Power Level AWGNPWR AWGNPWR? :-20 to 6.0 dB
○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○
Auto AWGN Power Level Off AWGNLVL OFF AWGNLVL? OFF
On AWGNLVL ON AWGNLVL? ON
Number of Number of
Measuremeut Measuremeut Frames --- FERTRANSMIT? n
Frames
Result Errors --- FERCNT? n [piece]
FER --- FERRATE? u [%/0.01%]
Confidence Level --- FERCFLVL? u [%/0.1%]
○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○
Pass/Fail PASS --- FERPASS? PASS
○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○
FAIL --- FERPASS? FAIL
○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○
PASS --- FERRSLT? 1
FAIL --- FERRSLT? 0
○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○
Status Status RUN --- FERSTATUS? RUN
○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○
STOP --- FERSTATUS? STOP
○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○
RUN --- FERSTAT? 1
STOP --- FERSTAT? 0
RemarksQuery Msg
Intermediate
class
Function Program Msg
Response
Msg
Function
details