24
Each VFO has a specific function under certain configurations.
VFO-B --- Used for manual search between VFO-A frequency to VFO-B frequency
VFO-C --- Used to transfer frequency from the memory channel
VFO-D --- Used to transfer frequency from the search channel
VFO-E --- Used to receive frequency below 25 MHz while in dual frequency receive mode
The AR5001D has an auto mode setting, there fore, in most cases a proper receive mode and frequency
steps are automatically selected.
3-5-1 TUNING FREQUENCY
3-5-1-1 ENTERING A FREQUENCY USING THE NUMERIC KEYPAD
While in VFO mode, enter the required frequency using MHz format followed by the [MHz] key.
(Example) Frequency entry of 81.3 MHz
Press the [8] key. Press the [1] key. Press the [.] key. Press the [3] key. Press the [MHz] key.
(Example) Frequency entry of 1134 kHz (1.134 MHz)
Press the [1] key. Press the [1] key. Press the [3] key. Press the [4] key. Press the [kHz] key.
Aborting frequency input
If you do not wish to complete the frequency data input, press the [CLR] key before completing the
input sequence with the [MHz] key.
Correcting frequency input
Press the [UP] key to delete the entry from the right hand side.
To Next Page
Loading...
