8
Operating anomalies
Should the AR5001D appear to behave strangely, normal op erations may be easily achieved by
performing the following steps:
1. Symptom: No control of the receiver.
Action: Turn off the power switch on the front panel. Leave it off for
approximately 10 seconds. Turn the power switch back on again.
Normal operation should be restored.
2. Symptom: The display freezes.
Action: Turn off the main power switch on the rear panel. Leave it off for
approximately 10 seconds. Turn the power switch back on a gain.
Normal operation should be restored.
Should the AR5001D still behave strangely, try a RESET as explained in chapter 9-13.
1-3 INCLUDED IN THIS PACKAGE
The following items are provided in this package:
1 AR5001D receiver
1 AC power adapter
1 Operating manual (this booklet)
1 Control command list
1 2GB SD memory card
Terminology
Search & Scan
If you have not used a wide band receiver before or is not familiar with the terminology used, it is very
important to understand the difference between SEARCH and SCAN modes.
SEARCH: The AR5001D provides several operations where transmissions
(active frequencies) may be automatically located by sweeping the receiver over
a wide frequency range, either from the currently displayed frequency traveling
upwards (or downwards) in a specified tuning increment (step) or by sweeping
over-and-over between two specified frequency limits. This process is known as
SEARCHING. As the name implies, this process can take a long time to find
transmissions due to their ‘often intermittent’ and brief nature. For this reas on, it
is best to slice large frequency ranges into smaller, more manageable pieces
To Next Page
Loading...
