AOR AR5001D - SCR (Analog Voice Descrambler); IF Shift

72
1. Press the [FUNC] key, and then press the [0] key.
2. Press the [DOWN] key three times to select “NB” in reverse contrast.
3. Rotate the sub dial to select on/off.
4. Press the [MHz] key to a ccept the entry and return to a standard display.
Alternatively, press the [CLR] key to abort entry, or press the [DOWN] key to move to the next item
on the configuration menu.
10-5 SCR (ANALOG VOICE DESCRAMBLER)
(Not available for US consumer version)
Analog voice descrambler is used to decode scrambled analog voice transmission by frequency
inversion.
Note: This function operates only in the NFM mode.
To activa te the function, perform the following steps:
1. Press the [FUNC] key, and then press the [0] key.
2. Press the [DOWN] key four times to select “SCR” in reverse contrast.
3. Rotate the sub dial to select the inversion frequency from the range of 2000 Hz ~ 7000 Hz in 10 Hz
step. Once properly selected, the decoded voice becomes intelligible.
4. Press the [MHz] key to a ccept the entry and return to a standard display.
To disable this func tion, press the [PASS] key.
10-6 IF-SFT (IF SHIFT)
IF shift is effective to reject any adjacent signal frequencies that cause interference to the receive
frequency. The IF shift operates to shift the IF filter passband to keep away from the interfering signal
without changing the receive frequency.
Note: This function operates only in the AM, SSB, AIQ modes.
To activa te the function, perform the following steps:
1. Press the [FUNC] key, and then press the [0] key.