16
Press the [SCAN] key again to initiate SCAN. If the receiver stops on an unwanted busy channel during
scan, it can be resumed using the [UP] key or [DOWN] key or by rotating the main dial.
To cancel scan, press the [SCAN] key again or press the [VFO] key.
Press the [FUNC] key, and press the [SCAN] key to activate a sub menu where bank link, pause,
de lay, level squelch, and voice squelch function can be configured.
PRIO – PR. SET
Press the [PRIO] key to activate/deactivate the priority function.
“PRIO” appears on the center top of the LCD when priority frequency is currently active (busy).
Press the [FUNC] key, and press the [PRIO] key to select the priority channel followed by the interval
of sampling.
VFO – V. MODE / 2F. BAND
Press this key to select VFO mode. The AR5001D has 5 VFOs (VFO-A through VFO-E) and the
selected VFO is identified by “VA”, “VB”, “VC”, “VD”, and “VE” icons on the right bottom of the LCD.
Press the [FUNC] key, and press the [VFO] key to access the VFO search menu where Delay, Voice
squelch and Mode squelch can be configured.
Press the [FUNC] key, then press and hold the [VFO] key for two seconds to activate/deactivate the
dual band receive function.
1 – SR. PROG
Figure ONE for the numeric input of frequencies, bank, channel numbers, etc.
Press the [FUNC] key, and press the [1] key to activate the Search Program menu where bank number,
lower frequency limit, upper frequency limit, receive mode, and text tag can be programmed.
2 – K. LOCK
Figure TWO for the numeric input of frequencies, bank, channel numbers, etc.
Press the [FUNC] key, and press the [2] key to activate the Key lock function. While activated, all front
pa nel keys except the [FUNC] key, and [POWER] key are disabled to prevent accidental misoperation of
the receiver. However, the volume and squelch controls remain operative.
To Next Page
Loading...
