49
The following parameters can be registered for each of the scan groups.
• Bank link setting
• Scan pause
• Scan delay
• Voice scan
• Mode scan
7-7-1 BANK LINK SETTING
To activate the bank link function, perform the following steps:
1. Press the [FUNC] key, and then press the [SCAN] key. The bank link screen will appear.
2. Rotate the sub dial to select the bank link group. Pressing the [PASS] key will toggle the link on/off.
3. To select the memory bank to be linked, enter the memory bank number using the numeric keypad.
If the memory bank is between 10 ~ 19, press the [.] key to move the cursor to the second row and
enter only the first digit of the memory bank number from the numeric keypad.
(Example: If the memory bank is 12, enter “2”.)
4. Press the [MHz] key to complete setting.
7-7-2 SCAN PAUSE
The scan pause parameter determines how long the receiver will remain on an active channel before
resuming scanning even if the channel is still busy. Scan pause helps keep you from having to manually
intervene to force the scan to continue or use channel lockout (pass).
The parameter ranges are off and 1 to 60 seconds. When the parameter is set to off, the receiver
remains on the busy channel until the received signal disappears or the memory channel is changed.
To set the scan pause parameter, perform the following steps:
1. Press the [FUNC] key, and then press the [SCAN] key. The bank link screen will appear.
To Next Page
Loading...
