EasyManua.ls Logo

Atlas Copco FOCUS 61

Atlas Copco FOCUS 61
118 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Troubleshooting Guide Focus 61 User Guide
9839 0211 01 Edition 2.0 112 (118)
22 SD B not ready
Cause: The SD card is not read by the device.
Solution: Make sure that your SD Card is inserted correctly in slot 2.2. If it is, check the functionality of
the SD Card on a computer. In case the SD Card is correctly inserted and the functionality is OK, refer to
your local service for further assistance.
23 SD A type error
Cause: The SD Card in slot 1.1 does not contain the correct contents to operate the system.
Solution: Make sure that both SD Cards (1.1 and 2.2) are in the correct slots. Replace the files on the SD
Card with valid firmware files. If this does not solve the problem, contact your local service for further
assistance.
24 SD B type error
Cause: The SD Card in Slot 2.2 does not contain the correct contents to operate the system.
Solution: Make sure that both SD Cards (1.1 and 2.2) are in the correct slots. Replace the files on the SD
Card with valid firmware files. If this does not solve the problem, contact your local service for further
assistance.
25 Card ID mismatch
Cause: The contents of the SD Cards were assigned to a different controller.
Solution: Take out both SD Cards and delete the “ID.dat” files on both SD Cards. If this does not solve
the problem, refer to your local service for further assistance.
31 LAN A hw error
Cause: This indicates a hardware error of the LAN A Network interface of the Focus 61 Controller.
Solution: Refer to your local service for further assistance.
32 LAN B hw error
Cause: This indicates a hardware error of the LAN B Network interface of the Focus 61 Controller
Solution: Refer to your local service for further assistance.
35 LAN A IP conflict
Cause: Focus 61 Controller detected an IP Conflict on network interface A.
Solution: Check your configuration whether another device in the same network has obtained the same IP
address as the Focus 61 network controller. If this is not the case, refer to your local service for further
assistance.
36 LAN B IP conflict
Cause: Focus 61 Controller detected an IP Conflict on network interface B.
Solution: Check your configuration whether another device in the same network has obtained the same IP
address as the Focus 61 network controller. If this is not the case, refer to your local service for further
assistance.

Table of Contents

Related product manuals