SmartROC D65 T4F 8 Drilling
104 No: 713944459.6 en
Symbol Name Explanation
Shortcut, drill plan This can be used for direct ac-
cess to the drill plan.
Current hole length
Penetration rate
The value at the top shows the
current hole length (m) and the
bottom value the penetration
rate (m/min). During autodrilling,
the average penetration rate for
the latest rod is shown. If the
automatic drill stop for attained
hole length has been reached,
the average penetration rate for
the entire hole will be shown.
Desired hole depth This is where the value for the
desired hole length (0-99.9m) is
entered. Drilling will be stopped
automatically once this hole
depth has been reached.
Drill bit position Shows the position of the drill bit
in metres
Rod indication Shows the number of drill steel
in the hole
Table23: Explanation of the symbols in direct selection menu F1.
n Pressure gauges: The pressure gauges show, from left: rotation, percussion and
feed pressure.
Adjustable parameter boxes are located under the pressure gauges for rotation and feed
pressure.
The feed pressure is set in this box. These values can be found in the Drilling-Parameters
menu and are marked with a drill bit to the left.
n Status bar: Shows directly warnings and information on the engine and drilling sys-
tem. A green box indicates that an automatic function is active. A red box immediately
turns off the diesel engine while a yellow one provides information that there is some-
thing that must be seen to (see status bar icon)
To Next Page
Loading...
