SmartROC D65 T4F 9 Angle instruments
131 No: 713944459.6 en
Length sensor calibration
1.
Operate the cradle up to mechanical stop.
2.
Go to the menu, Settings/Logging in/Length sensor calibration on the display for en-
gine and directional instruments.
3.
Reset cradle position (b) to zero and select "Activate Learn Mode Calibr. Sensor" (c).
4.
Activate drill feed and operate the cradle so that it passes both sensor B127 and
sensor B122.
5.
The distances will automatically appear in the boxes (a).
6.
Calibration finished, exit with ESC.
9.1.6 Depth measuring system
To keep control of the drill length, drill metres and penetration rate, there is a drill length
sensor available. The drill length sensor is mounted on the side of the feed beam and is
connected to the display via an I/O module together with the other components in the sys-
tem. The drill length instrument can be configured to show either the actual drilled length,
hole length measurement, or the vertical depth, vertical depth measurement. In the latter
case, the instrument will take into account the inclination of the hole and the displayed
value will consequently be less than the actual drilled length.
9.1.7 Depth measurement menu
The length instrument is accessed by pressing button F1 in the left-hand edge of the dis-
play. This provides direct access to the drilled length instrument menu.
To Next Page
Loading...
