SmartROC D65 T4F 8 Drilling
105 No: 713944459.6 en
8.1.5 Direct selection menu F2.
Direct selection menu F2. Settings 1
Quick Settings
In F2 a choice can be made between Settings 1 (see illustration above) and Settings 2
(see next illustration).
n Automatic close of drill support: Automatic close of drill support can be set here so
that the function can be disengaged for single-rod drilling.
n Final air blow before removal: Activates extra flushing when the hole is finished.
n Half rod flushing: Activates extra flushing when a half rod length is drilled.
n Extra flushing: Activates extra flushing before auto drilling.
n Cleaning: Before auto drilling, extra flushing and feed up and down for one drill pipe
length are activated.
n Automatic rod extraction: Select from three functions. Off = Normal extraction. Ro-
tation = Extraction with rotation on. Rotation and air = Extraction with both rotation
and air on.
n Hole Length/Depth: Selection of method of measurement.
n Activate HECL-Pump Manually: The HECL pump can be activated manually from
here and will remain active during an adjustable period of 1-90 minutes, after which the
pump must be reactivated for additional time.
n Ignore Chair Switch
Activated when the positioning levers need to be used when the operator is not seated, for
example, to get a better view through the rear window.
n Emergency mode, Length Sensor: Used if the length sensor has stopped working.
None of the pre-programmed stops will work but the rig can be used until the length
sensor has been rectified. Use rapid feed with great care as none of the stops are
working.
To Next Page
Loading...
Need help?
General
