Atlas Copco SmartROC D65 T4F User Manual

SmartROC D65 T4F 6 Operating
75 No: 713944459.6 en
6.9.2 Operation
!
NOTE: The gradient meter shows the chassis frame inclination and not the actual
ground inclination.
1.
Use the boom and feeder positioning control levers alternately to place the feeder
onto the feeder support. Make sure the boom and feeder are pointing straight ahead.
Positions for tramming.
A Normal position for tramming with feeder
located on the feeder support
B Only for tramming between boreholes if
ground inclination allows
2.
Raise the hydraulic jack (15). A double press UP will fully retract the jack
3.
Put the track oscillation cylinders to OPEN position. The diode on button (21)
should not be on.
4.
Activate TRAMMING (low speed/high speed) to a suitable position depending on the
character of the terrain. Button (5) or (6).

Atlas Copco SmartROC D65 T4F Specifications

General

Brand	Atlas Copco
Model	SmartROC D65 T4F
Category	Construction Equipment
Language	English