SmartROC D65 T4F 8 Drilling
109 No: 713944459.6 en
8.1.7 Direct selection menu F4.
Direct selection menu F4.
n Angle position: Upper value on left shows current tilt of feeder. Under this value is
an adjustable field where the desired tilt angle can be set.
n Angle position: The bottom value shows the current swing position of the feeder.
Under this value is an adjustable field where the desired side angle can be set.
In order to change the setting, this field must be highlighted and the field activated by
pressing the enter button on the display screen or the right drill panel. The value can then
be changed using the keys on the display screen or on the right drill panel. Once the de-
sired value has been set, it must be confirmed by pressing the enter button.
n The graphic on the right: Used as a working tool or aid to quickly find the correct
angle setting.
To get the lever to the desired value, the positioning lever must be moved in the opposite
direction to the way the needle is pointing. This will make the end of the needle shown on
the display screen move towards the centre of the graphic image.
The end of the needle reaching the centre of the graphic image means the feeder position
is at the desired value.
This setting can also be made using "Automatic feeder positioning" (option).
!
NOTE: Read more about direct selection menu F4 in the chapter "Angle instruments"
To Next Page
Loading...
