SmartROC D65 T4F 6 Operating
63 No: 713944459.6 en
Right control panel
4.
Ignition key to position for ignition on.
Wait for approx. 10 seconds so that the CANBUS system makes contact with the en-
gine's ECM. When the voltage at the battery symbol in the shortcut menu F5 shows
more than 0.0V then contact has been made.
Press in and turn the Ignition key to start position.
Engine starts
!
NOTE: Note
NOTE: Should the engine fail to start, stop trying after 20 seconds
and wait one minute before trying again.
5.
Release the Ignition key the key is spring-loaded and returns to the operating posi-
tion.
If starting is unsuccessful, check to see which symbols are shown on the display and
rectify the fault.
6.
Check the hydraulic oil temperature. If the hydraulic oil temperature is below 20 °C
(68 °F), drilling and high speed tramming will not work.
6.5 Stopping the diesel engine
!
NOTE: If the engine is hot, run it at idling speed for a couple of minutes before switch-
ing off.
To Next Page
Loading...
Need help?
General
