SmartROC D65 T4F 6 Operating
70 No: 713944459.6 en
!
NOTE: There may be a certain amount of delay in starting the automatic regeneration.
General conditions such as fuel consumption, charge pressure and exhaust temperat-
ure control whether it is started or not. Automatic regeneration is not permitted to start
when the soot level has reached 100%
6.8.3 Blocked regeneration
Automatic regeneration can be blocked if for some reason it is not suitable to permit it to
start, for example:
n When the exhaust extractor is installed on the rig during repairs.
n When personnel must be on the upper parts of the rig with the diesel engine running.
n When there is vegetation or other combustible materials in the immediate vicinity of the
exhaust.
To block the automatic regeneration mark (D) in the display and hold the enter button
pressed for 5 seconds and then Automatic regeneration blocked (B) is displayed.
Return to automatic regeneration by starting and completing a forced regeneration, al-
ternatively by restarting the drill rig.
!
NOTE: Automatic regeneration can only be blocked when the diesel engine is started.
Blocking is automatically reset when the ignition is switched off/on.
To Next Page
Loading...
