SmartROC D65 T4F 6 Operating
61 No: 713944459.6 en
Check point Inspection Instructions
Dust collector (DCT) Suction ability and filter cleaning In case of dust formation: Check
the filter in the filter holder and
suction hose and also the drill-
steel support's drill gasket.
The drill rig Visual check Look for any signs of leaks.
Return oil filter Operator's display in cabin Inspect for any signs of a leak. If
the pressure in the return oil fil-
ter exceeds the set value, a
symbol will be shown on the op-
erator's display.
Display for engine and directional
instruments
Visual check Check that none of the fault in-
dicator symbols is on. If a fault is
indicated in the status bar, stop
the unit and rectify the fault.
Table19: Checks.
6.4 Diesel engine starting
!
NOTE: Observe the display while at work.
1.
Set Battery main switch (S300) to position ON (1a) (Clockwise).
2.
Activate the drill rig's control system by pressing the CANBUS button (23), wait until
the startup screen appears on the display, which takes about 1 minute.
To Next Page
Loading...
Need help?
General
