SmartROC D65 T4F 9 Angle instruments
133 No: 713944459.6 en
Direct selection menu - F2.
The measurement method can be selected in the F2 shortcut menu "Parameters".
Use the arrow keys to select the Hole Length/ Depth button. Press Enter to switch
between the two alternatives. Confirm with Enter. Select the relevant menu with direct
selection buttons F1-F4.
Direct selection menu - F1.
2.
Resetting the hole length counter: Before starting each hole, the drill bit must be
placed on the ground. Activate the F1 or F4 menu by pressing F1 or F4 and the
cursor will be placed automatically in the reset box of menu F1 or F4. Press enter.
The current hole length will then show 0. The display will continue to show the selec-
ted menu.
To Next Page
Loading...
