Atlas Copco SmartROC D65 T4F User Manual

SmartROC D65 T4F 6 Operating
65 No: 713944459.6 en
Activate idle rpm with button (8) on the left-hand control panel.
Right operator's panel.
4.
Ignition key to position OFF (0). The engine may run at idling speed for a few
minutes. See section Delayed shutdown (DES) for information.
5.
When the engine has stopped, wait 2 minutes before you switch off the battery's main
power contactor. The DEF system requires this time to drain all hoses of fluid. The
DEF system may be damaged if fluid remains in the hoses after switching off.
6.
Put the Battery main switch in position OFF (1b) (see figure: Battery main switch).
!
NOTE: Note
NOTE: Always set the main power contactor to OFF (1b) once the
diesel engine has stopped after finishing work or for long-term stor-
age!

Atlas Copco SmartROC D65 T4F Specifications

General

Brand	Atlas Copco
Model	SmartROC D65 T4F
Category	Construction Equipment
Language	English