Operating Precautions
12
Install the unit out of reach of small children.
When performing phototherapy on the infant in the incubator, pay special attention to the
infant’s skin temperature and the incubator air temperature during the treatment.
The infant’s skin temperature and the incubator air temperature may rise due to the radiant heat generated by the
phototherapy unit.
Do not install the unit in direct sunlight or near a heating apparatus.
Do not expose the unit to extraordinarily high temperature or excessive humidity.
Do not place anything heavy on the unit.
Do not press strongly or rub the operation display of the control panel.
Pressing it strongly or rubbing it may damage the display or cause it to malfunction.
Be careful not to let any medical fluid adhere to the control panel.
Do not attach any peripheral device that is not specified by Atom to the incubator.
Check the operation of the peripheral devices.
If a device transmitting or receiving weak signals is installed near the unit, it may be affected by the electromag-
netic waves generated by the latter. Check the operation of the peripheral devices for any effect before using the
unit in clinical settings. Stop using the unit immediately if any trouble is detected.
When relocating the unit, watch your step so that you do not have your feet run over by a
caster.
Do not put your hand on an admittance panel when transporting the unit.
Pressing an admittance panel strongly may break it. At least two people are required to transport the unit by
holding the main body.
Watch out for any obstacles during transport.
If a peripheral device is attached to the main body, the unit may hit surrounding objects and get damaged or
broken.
To Next Page
Loading...
